Innovative power solutions.   Custom control systems.

North American Power & Controls, Inc.

Busduct to breaker transition section.

Busbar bending, punching, shearing.

Busduct transition pieces

Does you need to attach a bus duct to a circuit breaker or transfer switch?

Do you need a custom transition piece, custom offset, or a power cable landing?

Telecommunications, DC Plant Bus Work, Power Cable Landing, Transfer Switch Transition Section

We’re a UL listed panel shop.

Generator main breaker and load bank breaker assembly.

 

In this piece of switchgear, the generator main breaker is mounted in the upper portion of the enclosure, while the load bank breaker is installed in the lower section. Custom busbar assemblies interconnect the two breakers with the incoming top mounted bus duct feeder.

 

Here’s some photos of typical busbar assemblies:

Busduct to generator main breaker transition assembly.

 

We can build transition pieces for any of the major busduct manufacturers.

Switchgear internal bussing modification.

 

We built the pictured bussing  to allow the addition of an additional breaker within an existing 3 phase, 4 wire panel.

 

Design, build, install...we can ‘turnkey’ your busbar mods!

Generator main breaker– cable landing assemblies.

 

In this installation, the job specifications require all field power cables be equipped with two hole mounts (to prevent cable turning with consequent bolt loosening). The line side tabs had to  be extended to provide dual cable mounts– the factory provided aluminum mounting tabs would not meet the job specification.

 

Bullet proof reliability built in!

Deliveries and shipments:

North American Power & Controls, Inc.

1379 Lemon Street

Vallejo, CA 94590

 

Correspondence and billing:

North American Power & Controls, Inc.

PO Box 97

Benicia. CA 94510